Quote:
Originally Posted by hyperdude
I think that the pressure release valve (with the manual valve on the end) can be wired up so that once it reaches 120 and starts releasing pressure, it sends a signal to stop the compressor.
Again, I am not sure about this, but it's what I remember from what's been going on with our team the last two years.
|
No, you must use the
pressure switch from the KoP to provide a signal to the cRio (via Digital Sidecar). That is the only electrical component that has the capability of signaling the system pressure for control.
I wouldn't mind having this day repeat itself a few times. It would give us more time to work on our robot. - Mr.D [more] 
13-02-2010, 20:16
Similar Threads
Threaded Mode