[FTC]: Servo Help Please!

Bluedog24 · #1 13-02-2010, 22:30

I don't know how to program servos in RobotC. I haven't had the need to for the last few weeks.

What I'm trying to do is when button 1 is pressed servo1 turns and lets a ball drop into the catapult then the servo moves back to stop the balls. Then when you press button 2 a servo holding down the catapult releases, servo 2 stays in that position while the catapult goes. After the catapult is at the top servo 3 has a bar on it and brings the catapult back down and servo 2 locks it, servo 3 then moves back to its original position.

can someone help me understand programming servos in RobotC or give me a link to somewhere?

Thanks

Mike Betts · #2 14-02-2010, 04:16

Did you start at the beginning?

Bluedog24 · #3 15-02-2010, 20:31

Quote:

Originally Posted by Mike Betts

Did you start at the beginning?

Thanks, I was looking for that.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FTC]: LABView Servo Problem	Geek_Girl	FIRST Tech Challenge	9	16-02-2009 19:29
[FTC]: [FTC]: RobotC Template Problem (causing an FMS issue) and Potential Servo Prob	PackersFan	FIRST Tech Challenge	11	26-01-2009 21:25
[FTC]: Servo Reversing?	teamN20	FIRST Tech Challenge	0	26-11-2008 14:17
[FTC]: Servo Question	roborat	FIRST Tech Challenge	1	04-11-2008 18:29
[FTC]: FTC Servo-Motor Problem with Labview	dnhansen	FIRST Tech Challenge	1	26-10-2008 00:43