|
|
|
 Patents are an issue of law which, alas, has little to do with engineering or common sense. - Mike Betts [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Patents are an issue of law which, alas, has little to do with engineering or common sense. - Mike Betts [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Can't get cRIO to connect to Driver Station Software
OK...By the way, here's another question: During the flashing process, is it normal for the robot to disconnect and reconnect a couple of times?
By that second part, do you mean to download the default code and run it, and then try to enable it through the driver station? Also, when I hooked up the Analog Breakout and the other breakout (default is slot 2), I got a red light under "Robot" in Diagnostics when it usually was green. How do I fix that? 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver station can't find io module | remulasce | FRC Control System | 2 | 25-01-2010 01:24 |
| Can't connect your imaging tool to the cRIO? | jman1783 | Control System | 0 | 24-01-2010 14:07 |
| Wireless Router to Connect with Driver Station | Happyisgood | FRC Control System | 15 | 04-09-2009 00:02 |
| Can't change team # (was: Driver Station problem) | Lilszamora | FRC Control System | 2 | 03-02-2009 16:26 |
| cant get NXT to connect to controller station via bluetooth | cougarbotics | FIRST Tech Challenge | 5 | 04-12-2008 00:19 |
Hybrid Mode
