|
|
|
 “Chasing perfection is like trying to find a unicorn. If you go all around the world, you will not find a unicorn. However, you will find a whole freak load of stuff along the way.” - Karthik - Jacob Bendicksen [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
14-02-2010, 01:18
|
|||
|
|||
|
Re: CANJaguar for C++: Missing mode init messages?
Thanks for the answer! Guess I shoulda dug a little deeper.
What threw me off was the use of a switch() statement for a single case and in a place where there was no intent of ever adding additional cases. Usually you would just see a single if() statement to check the value, rather than the extra complication of a switch(). 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TeleOp Init/Stop vs. Auton-Iterative Init/Stop | Ziaholic | NI LabVIEW | 11 | 07-02-2010 22:19 |
| CANJaguar + BlackJagBridge plugin errors | Shinigami2057 | CAN | 1 | 06-02-2010 11:20 |
| Wierd basic init | Jeremy J | Programming | 5 | 06-02-2003 11:42 |
| Basic Init Error | yan184 | Programming | 5 | 14-12-2002 13:10 |
Threaded Mode