|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: Need a Full "Watchdog for idiots" explanation
In LabVIEW, if you press control-H you will turn on Context help. Hover your mouse over something you don't understand for a description of it.
Watchdog Kill just makes the watchdog expire immediately. When that happens, it is as if you pressed Disable on the Driver Station. It should have no worse effect on your motors than turning off the power. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hundreds of "Watchdog Expiration: System X" Errors | lollypop2020 | Programming | 21 | 18-02-2010 09:52 |
| Enabling yields one "Watchdog not fed" flash | Dylan5019 | Programming | 4 | 12-02-2010 23:45 |
| Help! Need a PAIR of 1.5" x 4" (to 6") cylinders, Bimba can't deliver | kmcclary | Pneumatics | 1 | 12-02-2010 13:53 |
| "watchdog not fed" error | Lumit | NI LabVIEW | 8 | 04-02-2010 18:45 |
| Need a "starter proposal" for new sponsor | Robocat1 | General Forum | 1 | 09-05-2006 18:48 |