|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
|
|||
|
|||
|
Re: SIGNAL LIGHT WONT WORK
when you wire the signal light, do you have the jumper wire in there? you need to run positive to one of the outsides, negative on the middle one, and positive on the other outside... you can do this by soldering the positive to split into two, or by just putting a jumper wire from one side to the other...
here comes cheesy paint drawing: ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dashboard wont work... | nadavsen2 | C/C++ | 2 | 22-09-2012 15:43 |
| Robot Signal Light | smcmahon | Electrical | 20 | 08-03-2009 18:11 |
| FRC Signal Light | railerobotics | Programming | 1 | 07-02-2009 17:01 |
| Signal Light | DustinB_3 | Electrical | 10 | 21-02-2007 13:10 |
| Festo valve.... why wont it work? | CHSguard72 | Pneumatics | 3 | 08-02-2003 19:07 |