|
|
|
 We draw the line when our students are more affectionate towards the tools rather than eachother. - ksafin [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| We draw the line when our students are more affectionate towards the tools rather than eachother. - ksafin [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Deploying Code??
Hi I have a doubt about how to deploy a code an run it as start up in the CompactRio?? I have done it several times but still theres no robot code indicator in the DS.
Thanks!  |
|
#2
15-02-2010, 14:20
|
|||||
|
|||||
|
Re: Deploying Code??
What Language?
In LabVIEW, you right-click on the FRC Boot-Up Deployment, click Build, wait for it to build, then right click on it again and click Run As Startup. When it finishes, it will ask you to reboot, say yes. When it reboots, you will see Communication in the Driver Station but not Robot Code, Robot Code will take another 10-30 seconds. Be patient, the entire boot-up does take some time. |
|
#3
15-02-2010, 16:49
|
|||
|
|||
|
Re: Deploying Code??
Thanks
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Code Deploying Problems[Java] | Cjdowney | Programming | 2 | 16-02-2010 18:06 |
| Need Help With Deploying Code | Darth Pbal | National Instruments LabVIEW and Data Acquisition | 2 | 02-02-2010 19:20 |
| Issue deploying Code | rudun | Java | 5 | 18-01-2010 21:24 |
| LabVIEW code deploying instead of running | linkhyrule5 | NI LabVIEW | 6 | 10-01-2010 14:57 |
| Problem deploying/running default code | blaxbb | FRC Control System | 0 | 10-01-2009 11:59 |
Linear Mode
