|
|
|
 Traction is good but a good driver will always win over a good robot. - Mike Norton [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Traction is good but a good driver will always win over a good robot. - Mike Norton [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#5
15-02-2010, 21:40
|
|||||
|
|||||
|
Re: Invoke Node in AB_Source_VI.lvclass Error
I found that all of my folders in Buzz15 (drivetrain, auton, etc) all show the read-only flag, yet I can still write to them. Using advice from someone else on the NI forum, I tried enabling debugging in the build properties and all was well. It rebuilt in the same directory and was happy. Now to figure out why it won't build when not debugging.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview: Feedback node doesn't reset on "stop" | kamocat | NI LabVIEW | 10 | 09-06-2016 23:43 |
| Should you invoke the wrath of <G14>, the whole world will know! | Ian Curtis | Rules/Strategy | 36 | 26-01-2009 13:28 |
| code interface node in LabView | Pneumaticsman | NI LabVIEW | 2 | 14-01-2009 22:57 |
| LebView Error -- Error 1055 occured at Property Node in FRC Create Project.vi->FRC Wi | RMS11 | Programming | 8 | 08-12-2008 18:20 |
| stupid Array error: Error [1300] stack frame too l | Validius | Programming | 7 | 27-01-2006 10:53 |
Threaded Mode