|
|
|
 Is all your information based on hearsay and miscellaneous posts by other people that don't know what they are talking about? - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Is all your information based on hearsay and miscellaneous posts by other people that don't know what they are talking about? - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
16-02-2010, 14:36
|
|||||
|
|||||
|
Re: How do you wire a Kick motor in labview?
You can easily make your Autonomous choice from the driver station before the match begins and you're required to step back from the controls.
In your code you'd use the Driver Station Get Dig In.vi to test any switches you attached to the Diriver Station via the Cypress IO board. Or without the Cypress IO board you can select your Autonomous from the I/O tab. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you wire the ADXL354 Accelerometer? | AustinGra | Sensors | 4 | 11-02-2010 23:33 |
| How do you wire a rotating component? | alleah2338 | Electrical | 7 | 12-02-2009 08:26 |
| How do you wire a limit switch? | JMH | Electrical | 1 | 16-02-2005 17:44 |
| how to wire the new two motor gearbox | Vince lau | Electrical | 10 | 14-02-2005 07:30 |
| How do you wire ADXRS150EB gyro? | MaxM | Electrical | 2 | 16-02-2004 13:43 |
Threaded Mode