|
|
|
 ...if two good things are good by themselves let's do them both together to make a better thing. So who's up for an apple pie burrito? - Katy [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...if two good things are good by themselves let's do them both together to make a better thing. So who's up for an apple pie burrito? - Katy [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
16-02-2010, 15:32
|
|||
|
|||
|
Re: Programming the Psoc
Mark - we at team 533 found the same problem with not finding the board on the port selection list when going throught the procedure. Reinstalling software on the classmate from a CD is not too palatable. Would it be safe to install the Cypress software on a second PC, move the hex file over from the Classmate with a thumb drive, and reprogram the Cypress board on the second PC?
Neil Heft Team 533 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PSOC Interface Card | Lafleur | Technical Discussion | 4 | 09-02-2010 13:26 |
| Programming the PSoC | PortugazD.Ace | Programming | 19 | 31-01-2010 13:14 |
| Programming the IR | Pi Boy | Sensors | 3 | 21-01-2008 15:47 |
| Programming the vex microcontroller to respond to commands on the serial port | crashoverride02 | Programming | 1 | 20-10-2006 14:17 |
| Programming The CMUcam for the Vex controller | 987HighRoller | Programming | 3 | 24-06-2006 15:27 |
Threaded Mode