Code not staying on the cRio

wwrobotics1452 · #1 16-02-2010, 13:54

How do we get the code to stay on the cRio when we turn the driver station on and off?

apalrd · #2 16-02-2010, 14:14

What Language?

In LabVIEW, if you hit the "Play" button (Deploy), it just stores code in RAM. To get it to do a full build and deploy, go to your project, click the [+] next to "Build Specifications", then right-click on "FRC cRio Boot-up deployment", and click "Build". When it is done, right-click on boot-up deployment again and click "Run As Startup". When it is done, you will be good.

EthanMiller · #3 16-02-2010, 15:35

Java, you just need to click the run button, and it should just work.

byteit101 · #4 16-02-2010, 15:47

Quote:

Originally Posted by wwrobotics1452

How do we get the code to stay on the cRio when we turn the driver station on and off?

I think you mean turn the robot on and off, the DS has no bearing on code staying put.
LabVIEW and Java are covered, so in Windriver, FIRST>Download after you have set the out file and your team number in Window>Preferences>First downloader prefs

BJT · #5 16-02-2010, 16:09

Quote:

Originally Posted by wwrobotics1452

How do we get the code to stay on the cRio when we turn the driver station on and off?

Duct Tape?

Sorry, just a bit of week 6 mentor insanity there

wwrobotics1452 · #6 18-02-2010, 17:17

Thanks. Problem solved!
@BJT-I wish it was that simple!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Code deploys but does not save to cRIO	Bill Taylor	NI LabVIEW	11	15-02-2012 20:30
Code Not Going to cRIO	mgamman	Java	3	15-02-2010 12:10
Downloading code: Netbeans does not reset cRIO	ellisk	Java	8	31-01-2010 19:02
cRIO Not Running Code?!?	JohnFogarty	Programming	11	17-01-2010 19:08
cRio keeps on staying red on the lab view connection test	bio hazard	Programming	1	14-02-2009 19:45