|
|
|
 It wasn't about the ROBOT, or about whether I was male or female, it was about getting to compete in something that was just SO cool. - BandChick [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It wasn't about the ROBOT, or about whether I was male or female, it was about getting to compete in something that was just SO cool. - BandChick [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
16-02-2010, 18:36
|
|||
|
|||
|
Re: labview help
OK with the second picture it will run at full speed without button one being pressed but when pressed the joystick values get cut in half. Also should I leave the axis value unbundled outside the case structure.
Last edited by zip100 : 16-02-2010 at 18:38. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview help | pedro696 | General Forum | 14 | 06-02-2010 19:34 |
| HELP!!!! we need help w/ compressors/pneumatics for teleop/autonomous in LABVIEW | rokenboker | NI LabVIEW | 9 | 05-02-2010 17:10 |
| Question|Help in LabVIEW | Rafael2215 | NI LabVIEW | 2 | 20-01-2010 10:47 |
| Labview Help, Rookie | Joraus | NI LabVIEW | 8 | 07-02-2009 17:08 |
| help: cannot get the picture in the labVIEW program .. (was: need help!! quickly!) | liad | LabView and Data Acquisition | 8 | 18-01-2006 12:20 |
Threaded Mode