|
|
|
 The Lord of the Bots.... - Bob Steele [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The Lord of the Bots.... - Bob Steele [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
PC with 1.1 DS update can't see Cypress IO.
I just installed the lastest updates on my desktop PC, and tried to use the Cypress IO of the first time on this machine.
The IO module had already been programmed on another laptop, and it works fine on the classmate display station. When I plug the module into my desktop, the "New Harware" wizard pops up, but can't find drivers for the module. (I even let it search the web) I tried un-installing both cypress components from the 1.1 DS update, and re-installing them, but it still won't install drivers. Any clues? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FRC Q&A Clarifies use of "Carrier' boards with Cypress FirstTouch Board | eStop Robotics | General Forum | 3 | 10-12-2010 15:38 |
| Continued problems with Cypress I/O Board | pheisinger | FRC Control System | 12 | 18-02-2010 09:57 |
| Can't see any values on dashboard | kevinb999 | C/C++ | 11 | 03-02-2010 14:41 |
| can't get R/C controller to work with EDUbot | sweet-chan | Robotics Education and Curriculum | 2 | 04-03-2005 01:35 |
| You can't see through an untouched starting wall of boxes | Digo | General Forum | 31 | 11-01-2003 12:01 |
Threaded Mode