|
|
|
 Got Valentine's day present from wife before leaving for work. Non-contact IR thermometer, two unscuffed pairs of safety glasses for competitions, bag of York peppermint patties. She understands me. - Greg Young [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
17-02-2010, 15:32
|
||||
|
||||
|
Re: labview help
If you are looking for a permanent speed reduction, I would think that you can multiply the unbundled "Y" value before sending it anywhere by something less than 1, and that would send less than the maximum voltage to the motors.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview help | pedro696 | General Forum | 14 | 06-02-2010 19:34 |
| HELP!!!! we need help w/ compressors/pneumatics for teleop/autonomous in LABVIEW | rokenboker | NI LabVIEW | 9 | 05-02-2010 17:10 |
| Question|Help in LabVIEW | Rafael2215 | NI LabVIEW | 2 | 20-01-2010 10:47 |
| Labview Help, Rookie | Joraus | NI LabVIEW | 8 | 07-02-2009 17:08 |
| help: cannot get the picture in the labVIEW program .. (was: need help!! quickly!) | liad | LabView and Data Acquisition | 8 | 18-01-2006 12:20 |
Threaded Mode