|
|
|
 I still have 3 good ligaments left and 2 events, so I should be fine :rolleyes: - esquared [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I still have 3 good ligaments left and 2 events, so I should be fine :rolleyes: - esquared [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
17-02-2010, 10:05
|
||||
|
||||
|
Re: Holding balls
Yes you can ,as you say, 'hold' the ball within the limits of the rules. You can't 'carry it' (ball not in contact with carpet). Read the manual.
|
|
#3
17-02-2010, 10:05
|
||||
|
||||
|
Re: Holding balls
As long as the ball doesn't go any further than 3" into your FRAME PERIMETER and doesn't leave the ground while you're POSSESSING it, you're all good.
|
|
#4
18-02-2010, 07:41
|
|||||
|
|||||
|
Re: Holding balls
Zip,
That is ball, singular. Be careful. Only one ball at a time. <G43> ROBOT BALL POSSESSION - ROBOTS may POSSESS only one BALL at a time. Violation: PENALTY. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Holding of program | chinckley | FRC Control System | 4 | 15-02-2009 13:53 |
| Holding a position in our arm | brennerator | Programming | 2 | 17-02-2007 04:02 |
| How is everyone designing their basket for holding balls? | MrBamboo | General Forum | 55 | 06-02-2006 15:53 |
| Pneumatics holding their position | sanddrag | Pneumatics | 22 | 15-01-2004 16:36 |
Linear Mode
