|
Re: Updated LabVIEW and Compressor no longer works
Quote:
Originally Posted by HansJ
My team updated our LabVIEW software yesterday morning. Our compressor was working the night before. When we tried to run the same code yesterday afternoon, it did not work. Nothing was changed on the robot. Has anyone else had this problem? Our solenoid still works, so the code is running fine.
Any help would be appreciated.
|
This appears to be a common theme around here. Search and you will find examples.
In the begin.vi, make sure the relay direction is set to "Both directions".
__________________
CalGames 2009 Autonomous Champion Award winner
Sacramento 2010 Creativity in Design winner, Sacramento 2010 Quarter finalist
2011 Sacramento Finalist, 2011 Madtown Engineering Inspiration Award.
2012 Sacramento Semi-Finals, 2012 Sacramento Innovation in Control Award, 2012 SVR Judges Award.
2012 CalGames Autonomous Challenge Award winner ($$$).
2014 2X Rockwell Automation: Innovation in Control Award (CVR and SAC). Curie Division Gracious Professionalism Award.
2014 Capital City Classic Winner AND Runner Up. Madtown Throwdown: Runner up.
2015 Innovation in Control Award, Sacramento.
2016 Chezy Champs Finalist, 2016 MTTD Finalist
|
“There are two ways to compete, one is to drag your opponent down, the other is to raise the bar and excel. Which do you think is more beneficial to you in the long run?” -- John Abele - Candice.E [more] 
18-02-2010, 10:00
Similar Threads
Linear Mode
