IP Adress Problems

Spatacus · #1 18-02-2010, 18:23

When we set up the IP adresses the correct way we don't get communication but when we have the classmate IP address set up to 10.24.32.5 the robot will move but the motor will be spotty and not move fluidly. How do we fix this?

Mark McLeod · #2 18-02-2010, 20:15

Since the classmate IP address is supposed to be 10.24.32.5, I'm not sure what you mean...

Spatacus · #3 19-02-2010, 18:28

I meant to say 10.24.32.6. When we have it set up to .5 the robot moves but the motors don't run fluidly.

Spatacus · #4 20-02-2010, 12:31

isnt the the IP adress of the drivers station is 10.24.32.5? when we set the IP adress of the classmate to 10.24.32.5 we have an IP adresss conflict with the drivers station.

MattD · #5 20-02-2010, 13:13

Quote:

Originally Posted by Spatacus

isnt the the IP adress of the drivers station is 10.24.32.5? when we set the IP adress of the classmate to 10.24.32.5 we have an IP adresss conflict with the drivers station.

The classmate is the driver station. It is supposed to be set to 10.24.32.5 as Mark said. Are you using something else as your driver station?

As for the motors cutting out, see if you're feeding the watchdog just a little bit too late.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the i.p. adress	tomy	NI LabVIEW	2	12-01-2010 22:24
DS Problems	popo308	FRC Control System	3	05-01-2009 22:16
IR Problems	Tottanka	Electrical	3	13-01-2008 15:07
Labview problems and code problems	ajsetter	Programming	25	18-01-2006 17:07
New Website adress for teams	Elgin Clock	CD Forum Support	1	08-01-2002 09:16