FIELD DRAWINGS

tomy · #1 18-02-2010, 19:29

I am the programmer on our team and we would like accurate measurements of the field and we can not find anything.If there is another thread I'm sorry to post this. We got some measurements but not all. We are looking for the whole field we got the dots for the balls but what is the measurement from the alliance wall to the center of the bumper. We have been looking for a while and we need the measurements to START working on the autonomous mode. Please post quickly

EricH · #2 18-02-2010, 19:33

The field drawings are in the same place as the Manual, listed under Section 6.

Michael Ogden · #3 18-02-2010, 19:33

The measurements should be in the rule book. Keep in mind that at least one update has altered the measurements.

EricH · #4 18-02-2010, 19:43

Quote:

Originally Posted by Michael Ogden

The measurements should be in the rule book. Keep in mind that at least one update has altered the measurements.

Not quite. The measurement given is "approximately one-third of the length of the field". Keep in mind that the dimensions in the Manual are only meant to be approximations, and the official drawings take precedence over those per Update #3.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Field drawings missing	Gary Dillard	General Forum	1	15-01-2010 21:23
How to generate drawings like the published field drawings?	shawn1231	CAD	5	19-03-2009 08:53
Field Corner Dimensions Missing from Field Drawings?	Don Wright	General Forum	2	13-01-2009 19:57
[FTC]: Field Drawings?	Madison	FIRST Tech Challenge	1	14-09-2008 15:16
Field Drawings Update	Justin Howard	OCCRA	5	29-09-2001 10:28