|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#5
|
|||
|
|||
|
Re: Help Solenoid Programming
To team 2987,
Im new to programming too, but i'm pretty sure i fugured out the enumeration error for adding solenoids. when you have your solenoid icon that says Open on it (should be green, just like the other one) on the left side hover over the edge until the little box thing says solenoid channel. right click on that and go to create -> constant. this will give you the option of choosing what number solenoid you have. be sure that if you add more solenoids to the begin etc... VI that you add the same amount with the same names to the rest of your VIs... hope this helps. Tasha |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview Solenoid Programming | 3p1c w1n | Programming | 12 | 12-02-2010 17:29 |
| Solenoid Programming Issue. | Dr. Manhattan | Pneumatics | 2 | 10-02-2009 17:42 |
| solenoid programming | holty531 | Programming | 0 | 10-02-2008 16:17 |
| Programming a Solenoid | Brigander | Pneumatics | 4 | 17-02-2007 14:06 |
| Solenoid Programming | duckshepherd | Pneumatics | 1 | 17-02-2003 09:15 |