|
|
|
 General rule of thumb:
"If it moves and it shouldn't, use duct tape. If it should move and it doesn't, use WD-40.":) - ben_0614 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| General rule of thumb:
"If it moves and it shouldn't, use duct tape. If it should move and it doesn't, use WD-40.":) - ben_0614 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Logitech attack 3 joystick problem
after spending the day trying to perfect our tele-op program our logitech 3 attack controller was not operating correctly. when the joystick was in a neutral position the motor that it was controlling was spinning at nearly full speed. i am having trouble finding the error in programming and am unsure if there is just something wrong with the actual joystick. if anyone could help me in finding out how to adjust the dead band of the controller it would be greatly appreciated.
|
|
#2
18-02-2010, 21:50
|
|||||
|
|||||
|
Re: Logitech attack 3 joystick problem
The location of the joystick when the computer first sees it is treated as neutral. If the joystick wasn't physically centered at that moment, it will be offset until the next time it is reconnected.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Joystick Problem | The Last Don | Programming | 2 | 13-02-2010 13:13 |
| Buttons on a Attack 3 Joystick useing LABView | morg102 | NI LabVIEW | 14 | 02-02-2010 23:28 |
| Logitech Dual-Action Gamepad - Axis Problem | Mr. Lim | Programming | 5 | 16-01-2010 19:28 |
| logitech extreme 3d pro joystick | mahmosh | Control System | 4 | 24-02-2009 08:36 |
| joystick problem | archiver | 2000 | 12 | 23-06-2002 23:08 |
Linear Mode
