|
|
|
 Bumper quality is an "attention to detail" measure. Teams that get little things right tend to do better on the big things. - vhcook [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Bumper quality is an "attention to detail" measure. Teams that get little things right tend to do better on the big things. - vhcook [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
02-19-2010, 01:26 PM
|
||||
|
||||
|
Re: Potential Issue with the C++ CANJaguar Implementation
Would it be expecting an Absolute Encoder that outputs a 0-5 V signal based on shaft position? If you are working with a position control mode, that is what I would expect Vs using a relative quadrature encoder.
Mike R. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Weird issue with the power distribution block | X-Istence | Electrical | 17 | 03-08-2009 06:32 PM |
| [FTC]: [FTC]: RobotC Template Problem (causing an FMS issue) and Potential Servo Prob | PackersFan | FIRST Tech Challenge | 11 | 01-26-2009 09:25 PM |
| An Issue with downloading the Master Code. | Neil [Coconuts] | Programming | 6 | 02-07-2008 02:03 PM |
| Issue with downloading code to the 2007 RC | thefro526 | Programming | 3 | 02-10-2007 05:26 PM |
| Potential Problem with "fighting over the goal" | Kyle Fenton | General Forum | 4 | 02-17-2002 10:21 AM |
Threaded Mode