Help! Can't get PWMs to work...

dan_h · #3 02-19-2010, 08:54 PM

Quote:

Originally Posted by 1075guy

Do you have 12V wired into the sidecar through the WAGO connector? are all three lights at the bottom of the sidecar on, is the sidecar connected to the DIO module in slot 4 on your cRIO?

12V -> Yes, lights -> On, Sidecar connected to slot 4 -> Yes

In addition, the expected pattern blinks on the RSI light.

Interestingly, the dashboard shows now change in the PWM output level, which leads me to believe that it's probably not a connection problem, and more likely a software problem ... it's just that I can't find anything that's out of place. I'm going to try formatting and reflashing the cRio tomorrow, because I'm out of ideas.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can't get program to execute	Thxe	C/C++	3	02-09-2009 08:33 AM
CANT GET THE CANERA CODE TO WORK!!!! plz HELP!!	its da PAT!!!	Programming	3	02-18-2007 11:07 PM
Can't get EDU RC to print things.	devicenull	Programming	2	01-29-2006 04:42 PM
can't get R/C controller to work with EDUbot	sweet-chan	Robotics Education and Curriculum	2	03-04-2005 01:35 AM
Why can't we get along?	Sean_330	General Forum	23	03-19-2003 09:38 PM