Soldering Wires to Motors

19-02-2010, 21:02

rsegrest

@ least I'm OVER the rock THIS time

FRC #2582 (PantherBots)

Team Role: Coach

Join Date: Jan 2008

Rookie Year: 2008

Location: Lufkin, TX

Posts: 414

Soldering Wires to Motors

So, we are using a banebot motor to power a shaft for ball control. If you have worked with the banebots you know the posts leads are EXTREMELY small. We have not yet been able to find crimps small enough to fit the leads. Are we allowed to solder the wires to the leads on the motor and if so what are the risks to the banebot if we do this?

Thanks everyone...

__________________

Impossible is just a big word for small men who find it easier to live in the world they've been given than to explore the power they have to change it. Impossible is not a fact. It's an opinion. Impossible is not a declaration. It's a dare Impossible is potential. Impossible is temporary. Impossible is nothing.
~ Unknown

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Soldering the accelerometer help	LavaEagle	Electrical	4	10-02-2010 00:26
Soldering questions	Nathan	Electrical	18	11-09-2007 21:55
Crimping/Soldering	stevex	Electrical	10	01-02-2005 08:32
check this out with soldering	tiffany34990	Chit-Chat	1	16-08-2004 21:14

All times are GMT -5. The time now is 16:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.