|
|
|
 Thanks Autodesk! - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Thanks Autodesk! - Al Skierkiewicz [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Camera not working
For some reason, the camera doesn't work. The camera's IP is still 192.168.0.90, we ran Setup Axis Camera, so there's an account on it with username and password FRC/FRC. We installed all the updates for Wind River up to 4.3, Labview up to 2.1, and Driver Station up to 1.1. We tried to use the unmodified Vision Demonstration code, but nothing happened in the Dashboard. We've reinstalled everything, including Wind River, but it still doesn't work. The camera is the only thing we're having trouble with. What should we do?
Also, whenever we try to ping the camera's IP, it says "Destination net unreachable". Is this normal? Last edited by RevusHarkings : 20-02-2010 at 14:35. Reason: Extra info 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera particleToImagePercent not working | TPNigl | Programming | 3 | 19-02-2010 14:53 |
| Camera not working... | AG-chadd | Programming | 4 | 04-02-2009 22:10 |
| Camera not working | LinuxMercedes | Programming | 10 | 13-01-2009 10:18 |
| Camera not working | st1nkm4n | Programming | 7 | 02-02-2006 08:22 |
| Camera not working | st1nkm4n | Programming | 0 | 31-01-2006 19:23 |
Threaded Mode