|
|
|
 Meanwhile I'm over here with with my completely see-through poly-carbonate blocker prototype laughing. - JohnFogarty [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Meanwhile I'm over here with with my completely see-through poly-carbonate blocker prototype laughing. - JohnFogarty [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
02-20-2010, 03:08 PM
|
|||
|
|||
|
Re: Programming the Cypress Board
The Cypress board should be plugged into the USB on the drive station. Then just use the drive station routines like GetDigitalIn and SetDigitalOut. Check the DriverStation documentation in the help found in your WindRiver docs/extensions/FRC directory.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cypress board LAYOUT | SteveD | FRC Control System | 11 | 01-23-2010 11:23 AM |
| Sensitivity of Cypress board | SteveD | Control System | 1 | 01-21-2010 11:22 AM |
| Cypress board | bls0620 | Electrical | 4 | 01-17-2010 11:22 PM |
| Cypress Board Configuration | Geek 2.0 | FRC Control System | 12 | 01-17-2010 04:23 AM |
| Cypress IO board connect | SteveD | FRC Control System | 12 | 01-16-2010 04:46 PM |
Threaded Mode