Trouble with Limit Switches

[wireties]

it is probably not wired correctly, those things are pretty foolproof

wire ground and signal to the two terminals that short when the switch is closed - run this to a digital I/O input and use the DigitialInput class

it kinda has to work

[Alan Anderson]

You do have the switch connected between ground and signal, right? And your wires go to the COM and NO pins on the switch, right?

Because of the pullup resistors on the Digital Sidecar's DIO pins, a Normally Open switch will read True when it's not active, and False when it is, so it looks like you got that part correct.

How are you using the switch value to zero the motor control? Show us that part of your code; it sounds like it isn't working properly.

[jmanela]

just to test, you could put some kind of indicator on the front panel of whatever you are doing to make sure you are getting values at all. (or just probe the DIO get boolean wire)

[Alan Anderson]

Originally Posted by jmanela

just to test, you could put some kind of indicator on the front panel of whatever you are doing to make sure you are getting values at all. (or just probe the DIO get boolean wire)

The default Dashboard shows the state of the DIO pins (it updates only twice a second).