|
|
|
 On a side note... "Think outside the robot." - I kinda like that. I'll have to use that in a meeting someday.... - Not2B [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| On a side note... "Think outside the robot." - I kinda like that. I'll have to use that in a meeting someday.... - Not2B [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Bumper Rules?
We were not able to find 2 1/2 in pool noodles. We have been using 2 1/4 in foam pipe insulators. Does anyone know if that is OK? Also, we are confused about rule RO7L - joints between bumper sections and their radial projections of corners must be filled with soft bumper materials" Are they talking about that little square between the bumper and the frame that is left - see illustration on page 12 of the manual (section N)
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Bumper Rules | Cyberphil | Rules/Strategy | 5 | 07-01-2009 13:45 |
| Bumper Rules | Bochek | Technical Discussion | 7 | 10-02-2008 23:48 |
| Bumper rules | robotraj111 | Kit & Additional Hardware | 1 | 19-02-2006 20:36 |
| Regional-specific rules, etc., and do the referees read the rules? | Kit Gerhart | Rules/Strategy | 53 | 18-04-2005 08:51 |
Threaded Mode