|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: Trouble with Limit Switches
You do have the switch connected between ground and signal, right? And your wires go to the COM and NO pins on the switch, right?
Because of the pullup resistors on the Digital Sidecar's DIO pins, a Normally Open switch will read True when it's not active, and False when it is, so it looks like you got that part correct. How are you using the switch value to zero the motor control? Show us that part of your code; it sounds like it isn't working properly. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Limit Switches | Wicked | NI LabVIEW | 9 | 04-03-2009 17:21 |
| Limit Switches | popnbrown | NI LabVIEW | 1 | 10-02-2009 22:39 |
| Using Limit Switches with the Arm | iwin2000 | Programming | 3 | 18-02-2008 03:52 |
| How to connect limit switches with pwm cables?????!!!!! | jesusescobar | Kit & Additional Hardware | 4 | 18-02-2007 18:15 |
| limit switches | stephenthe1 | Programming | 28 | 11-05-2005 16:37 |