Code problems, I think.

You guys can send [Wisconsin] some warm Florida weather, its getting cold up here again. - Ricky Q. [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Code problems, I think.

Thread Tools

Rate Thread

Display Modes

21-02-2010, 14:08

Josh987

That's what I say.

AKA: Josh

FRC #1565 (Think Tank Tech)

Team Role: Programmer

Join Date: Oct 2009

Rookie Year: 2008

Location: Hespeler, Canada

Posts: 17

Josh987 is an unknown quantity at this point

Code problems, I think.

The code deploys without error but when I take the joystick to all forward or backwords (1, -1) or full left or right, the motors stop working alltogether. If i slowly ramp up to full left, right, forward, or backwards though it works fine. I think this is a code problems so any help is much appreciated.

__________________
Charlieeeeee, Candy Mountain

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems Combining Camera Code and Driving Code	cmurdoch	Programming	20	10-02-2007 16:34
Problems integrating CMUCAM code and IFI Default Code	Windward	Programming	2	06-02-2007 16:48
problems using gyro/adc code with camera default code	tanstaafl	Programming	7	22-01-2006 23:09
Labview problems and code problems	ajsetter	Programming	25	18-01-2006 17:07
Array problems( i think....)	Andrew Blair	Programming	10	22-09-2005 19:57

All times are GMT -5. The time now is 11:08.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.