|
|
|
 First check for any bind in the transmissions, especially chain. Next, check to see if the motors are O.K. Use code as a last resort. - Paul Copioli [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| First check for any bind in the transmissions, especially chain. Next, check to see if the motors are O.K. Use code as a last resort. - Paul Copioli [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: LEDs on the Cypress PSoC
The dashboard saves many settings including the I/O settings. It will load and use them the next time it is run.
Greg McKaskle |
|
#2
21-02-2010, 15:55
|
||||
|
||||
|
Re: LEDs on the Cypress PSoC
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming the Cypress Board | NinjaSpawn94 | C/C++ | 1 | 20-02-2010 15:08 |
| Programming the Psoc | railerobotics | Technical Discussion | 5 | 18-02-2010 10:10 |
| Wiring Switches to the PSoC board | Raj1977 | Electrical | 13 | 07-02-2010 23:24 |
| Programming the PSoC | PortugazD.Ace | Programming | 19 | 31-01-2010 13:14 |
| Cypress PSoc Programmer Port Selection problem | Steven_585 | FRC Control System | 2 | 23-01-2010 23:06 |
Hybrid Mode
