PWM cables in Inventor

Noamr · #1 21-02-2010, 20:17

I was wondering if anyone has a clear explanation of how to create realistic PWM cables in Inventor.

Thanks in advance,
Noam
MisCar 1574

mpinventor19 · #2 21-02-2010, 20:34

We literally just asked ourselves that question today. We had the idea of using the ribbon cabel comand to create the PWM Cables. If you have a better solution we would like to hear it but we also are still trying to figure out the Ribbon Cable command on inventor.

Noamr · #3 21-02-2010, 20:55

We would also appreciate some help with Inventor pneumatics...thanks

Terror Drone · #4 01-03-2010, 18:47

Quote:

Originally Posted by Noamr

We would also appreciate some help with Inventor pneumatics...thanks

Well, you can get the 3d models of Bimba cylinders. And it's not hard to make a pneumatic piston, you just need to make the bores correct and then add details like threaded connectors and bolt holes, fitting inputs and such.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PWM cables in Inventor?	acidrain2012	Inventor	0	14-03-2009 00:01
PWM Cables	Mechanical	Electrical	6	05-05-2008 21:35
custom PWM cables	bruss6	Electrical	6	16-02-2007 08:33
PWM Cables	Alex Cormier	FIRST Tech Challenge	15	13-08-2006 09:48
PWM Cables	zachriggle	Electrical	3	04-02-2006 13:54