|
|
|
 ALL technology is run on 'Magic Smoke' contained within the device. As everyone knows, whenever the magic smoke is released, the device ceases to function. - kmcclary [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ALL technology is run on 'Magic Smoke' contained within the device. As everyone knows, whenever the magic smoke is released, the device ceases to function. - kmcclary [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Analog Out on the Cypress PSoC (enhanced modeO
Hi All,
Has any one used the enhanced mode on the Cypress SPoC and played with the ANALOG OUTPUTS ? I have used the compatibility mode and am able to get the ANALOG INPUT working fine (except for the high impedance noise on the unused AI lines). I have been able to use switches on the PSoC and reflect the switch settings back to the (virtual) LEDs on the DS - so far so good. I am using Windriver C++ and the standard DriverStation class. Is there a Analog Out method in the DirverStationEnhanced class that can be used to send an analog signal back ? Greg M may know the answer to this (also!) ... It would be nice to have a manual about PSoC as applied to our FIRST scenrios. Many thanks in advance. Gopal |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LEDs on the Cypress PSoC | mcbean | Programming | 4 | 21-02-2010 15:55 |
| Programming the Psoc | railerobotics | Technical Discussion | 5 | 18-02-2010 10:10 |
| Analog Input tied to Accelerometer on Cypress | offramp13 | FRC Control System | 2 | 05-02-2010 02:40 |
| Programming the PSoC | PortugazD.Ace | Programming | 19 | 31-01-2010 13:14 |
| Cypress PSoc Programmer Port Selection problem | Steven_585 | FRC Control System | 2 | 23-01-2010 23:06 |
Threaded Mode