|
|
|
 The person that I would, without a doubt, would like to meet the most is my sanity. - lukevanoort [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The person that I would, without a doubt, would like to meet the most is my sanity. - lukevanoort [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
22-02-2010, 15:11
|
|||
|
|||
|
Re: Analog Out on the Cypress PSoC (enhanced modeO
Thanks Greg..
I checked in the C++ documentation and I see there is SetAnalogOut()! I did not see this before - this is cool. The other thing - the P2 connector has a sticker of some sort on it. It would be nice to know if we can remove it and also what type of connector plugs in to it (rather than breadboard it with individual wires). Eric - What I have been doing is experimenting with feedback for the past few years but with each driver station changing it has been interesting! Last year I was on the verge of converting a generic PC gamepad to a good driver station operator interface. There the fun was in using the built-in motors to generate some sort of tactile feedback. With this Analog Output - something like that could be done, I think. I will share with you what I come up with! Thanks again! Gopal |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LEDs on the Cypress PSoC | mcbean | Programming | 4 | 21-02-2010 15:55 |
| Programming the Psoc | railerobotics | Technical Discussion | 5 | 18-02-2010 10:10 |
| Analog Input tied to Accelerometer on Cypress | offramp13 | FRC Control System | 2 | 05-02-2010 02:40 |
| Programming the PSoC | PortugazD.Ace | Programming | 19 | 31-01-2010 13:14 |
| Cypress PSoc Programmer Port Selection problem | Steven_585 | FRC Control System | 2 | 23-01-2010 23:06 |
Threaded Mode