|
|
|
 Woody says that gracious professionalism is "acting how you would if you grandmother was watching you"... some people must have some really crazy grandmothers. (: - Cappeh [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Crio Problem
Hey my friends:
Two days ago our robot was working very good, yesterday I can't move sensors, camera, encoder.But only the motor can work I dont know why, is the same program, the same conextion, I changed the wires conexion but the problem is the same I am thinking if is the problem with Crio so I want to Know if could be this problem, What happens if I reset the Crio??? the problem is common??? Thank you!! PD: What update I need for restart the Crio?? 
|
|
#2
10-03-2010, 15:52
|
||||
|
||||
Re: Crio Problem
All the updates you need are on usfirst.org, if yo haven't updated he CRIo image then that might be a part of your problem. You might also check to make sure your crio and camera are electrially isolated fom your frame, we had a CRio blow a fuse b/c it wasnt isolated. And resetig the crio basically rboots it.
Hope this helps, and sorry for the mistakes... Typing on an iPod touch is not easy!
|
|
#3
30-03-2010, 10:21
|
|||
|
|||
|
Re: Crio Problem
Check your pwm system for shorts. If any of the pwms are shorting between the hot and ground, the 5 volt current will be diminished, and will not work. Check all inputs and outputs.
Hope this helps
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO output problem | alex42 | FRC Control System | 1 | 27-01-2010 22:28 |
| cRio problem | specs101kid | Programming | 4 | 21-01-2010 16:19 |
| cRIO communications problem | alex42 | FRC Control System | 5 | 16-01-2010 20:22 |
| cRIO Problem | Pneumaticsman | NI LabVIEW | 8 | 10-01-2009 11:59 |
| cRIO plugin problem | gabrielse | National Instruments LabVIEW and Data Acquisition | 3 | 18-12-2008 11:30 |
Linear Mode
