|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: Encoder Problems after update???
Opening a SubVI like Encoder Open will show you the defaults, not the actual values being fed to it. Don't worry about the "disabled" and "invalid" things you see there.
It's possible that your DevRefs aren't doing what you think they are. If the names aren't exactly the same on the Set and the Get, it won't work. If you try to do a Get inside Robot Main before the Begin vi has done the Set, it won't work. When you get a chance, run Robot Main, open the block diagram where you're trying to read the encoders, and probe the DevRef going into the Encoder Get to see if it looks reasonable. Oh, and make sure you're doing an Encoder Start immediately after the Encoder Open. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Encoder Problems | BBHSrobotics | Java | 2 | 22-02-2010 11:18 |
| Encoder problems | Pausert | NI LabVIEW | 3 | 18-01-2010 12:33 |
| Problems after the update?? | Straberrie | Programming | 2 | 17-02-2009 07:11 |
| Problems after 3rd update applied | pheisinger | FRC Control System | 3 | 13-02-2009 22:47 |
| Encoder Problems | bjimster1 | Programming | 2 | 10-02-2007 08:04 |