|
|
|
 There is no rule that specifically states that you must obey the law of physics during the competition. This may be an oversight. - bmather [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There is no rule that specifically states that you must obey the law of physics during the competition. This may be an oversight. - bmather [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Victor controller problem
We are experiencing a problem with our victor controller modules. They run well for a short time then slowly deteriorate. Yet if we connect the motor to a spike, they work fine. We used the same configuration last year with good results. Is there a tuning procedure, or something we need to do to calibrate these? We've never experienced this before.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Victor problem | Andy Baker | Electrical | 15 | 24-06-2003 09:49 |
| Ok one problem | cantwell03 | Programming | 3 | 13-02-2003 07:28 |
| The problem with scouting... | archiver | 2001 | 10 | 23-06-2002 23:49 |
| joystick problem | archiver | 2000 | 12 | 23-06-2002 23:08 |
| Major problem with chipphua motors | aka Scott White | Motors | 18 | 19-03-2002 19:44 |
Threaded Mode