|
|
|
 Step 1: Get a blue banner.
Step 2: Wave it everywhere until your School Board acknowledges your existence.
We haven't gotten to Step 1 yet, unfortunately. - Chris is me [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
24-02-2010, 19:28
|
||||
|
||||
|
Re: Encoder Problems after update???
Hello,
If this is 2009 code in the example, is it still valid for 2010? We have the next version of Labview, 8.6 and update 2.1. We never did anything this elaborate in 2009 to have the encoders operate. So from the far left through Start Encoder is in BEGIN. Use the DevRef to go from BEGIN to TELEOP and BEGIN to AUTON. We'll give it a try. . . 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Encoder Problems | BBHSrobotics | Java | 2 | 22-02-2010 11:18 |
| Encoder problems | Pausert | NI LabVIEW | 3 | 18-01-2010 12:33 |
| Problems after the update?? | Straberrie | Programming | 2 | 17-02-2009 07:11 |
| Problems after 3rd update applied | pheisinger | FRC Control System | 3 | 13-02-2009 22:47 |
| Encoder Problems | bjimster1 | Programming | 2 | 10-02-2007 08:04 |
Threaded Mode