|
|
|
 The JVN/Karthik segment should have more than enough spontaneity for everyone - Matt Krass [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The JVN/Karthik segment should have more than enough spontaneity for everyone - Matt Krass [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
24-02-2010, 20:55
|
||||
|
||||
|
Re: Gyro Wiring?
The gyro needs to hook up using a 3 wire "pwm cable". Solder either the pins of the pwm cable or a 3pin female header (don't know where to get them right off hand). The outer edge is negative (black wire), you don't need to hook up both sets just the outer set that says "gyro". The female end goes to the analog I/O default is port#1 if you have it hooked up for use on the default driverstation diaplay.
Last edited by Mike AA : 24-02-2010 at 22:10. Reason: digital to analog forgot it |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring Gyro | PingPongPerson | Electrical | 1 | 11-02-2010 21:27 |
| Gyro wiring? | Phoenix Spud | Electrical | 7 | 12-01-2009 13:58 |
| Help: wiring ADXRS300EB Gyro Eval Boards | de_ | Sensors | 3 | 18-03-2008 22:21 |
| 2003 Gyro Wiring Harness | DukesAZ | Electrical | 3 | 03-02-2005 18:20 |
| 2003 Gyro Wiring Harness | DukesAZ | Technical Discussion | 3 | 03-02-2005 18:20 |
Threaded Mode