|
|
|
 So, volunteer Field Resetters are to meet in the school's weight room for training? :D - Roger [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So, volunteer Field Resetters are to meet in the school's weight room for training? :D - Roger [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
25-02-2010, 15:13
|
||||
|
||||
|
Re: New BDC-COMM Version 88
Try loading the firmware again using the 2CAN interface. Make sure that the problem Jag is the only one connected to the CAN bus. I have noticed that once in a while the firmware update does not take the first time and the Jag gets stuck in bootloader(no LED). A re-flash after a power cycle has always fixed this for us. If this does not work then you may need to re-flash the bootloader using the JTAG interface.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to find BDC-COMM utility? | rrossbach | Control System | 5 | 31-07-2011 00:43 |
| BDC-Comm Problems when setting jaguars up for CAN | LeelandS | Programming | 12 | 02-02-2010 16:00 |
| Trouble getting BDC-COMM to see the black Jaguar | Randy Forgaard | CAN | 5 | 27-01-2010 09:14 |
| New version of FIRSTclipse: 0.0.3 | Astronouth7303 | Programming | 8 | 18-02-2007 21:06 |
| New version of WPILib | BradAMiller | Programming | 26 | 27-01-2007 15:49 |
Threaded Mode