|
|
|
 The only basis on which a team should be awarded the chairmans award is the content of the submission, not the way in which it is presented. - KenWittlief [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| The only basis on which a team should be awarded the chairmans award is the content of the submission, not the way in which it is presented. - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Axis camera stopped working
Our axis camera is no longer streaming video to the dashboard. We are using v20 of the firmware, v4.3 of WPIlib, and v1.1 of the dashboard. Our camera was streaming video early in the season. I have tried using the 2010 vision demo also without success. What other information would be helpful? How should I try to fix this?
Last edited by Chinmay : 26-02-2010 at 23:32. 
|
|
#2
27-02-2010, 00:52
|
||||
|
||||
|
Re: Axis camera stopped working
Try following the instructions on page 58 of the Control System Manual Section 2to reconfigure the camera.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AXIS 206 Camera not working | Wicked | NI LabVIEW | 14 | 25-01-2010 21:04 |
| AXIS 206 camera not working | Wicked | NI LabVIEW | 3 | 21-01-2010 10:05 |
| GUI stopped working | jgannon | Programming | 5 | 08-04-2007 01:09 |
| Camera Working...then mysteriously stopped | comwiz7 | Programming | 14 | 27-01-2007 12:11 |
Linear Mode
