Pneumatic compressor not starting

[nick_champ_2]

We need help programming the compressor to start in auto and teleop.

attached is a copy of the code.

[Mark McLeod]

Sorry, I can't see your code attachment where I am.

The compressor only needs to be in Begin.vi, then it's actually active in the background everywhere else.
http://www.chiefdelphi.com/forums/at...8&d=1264605003

Here's the full set: http://www.chiefdelphi.com/forums/sh...9&postcount=15

[Speeder]

Move the start.vi so it follows the setref.vi

That's the only place you will need it for both Autonomous and Teleop.

[Alan Anderson]

Originally Posted by nick_champ_2

We need help programming the compressor to start in auto and teleop.

attached is a copy of the code.

The compressor part of Begin.vi looks fine. There's no need for you to do anything special in Autonomous or Teleop; the compressor control is handled automatically by a separate task that the Compressor Start sets up for you. You can close the compressor in Finish.vi if you're a stickler for making things "just so", but it really won't make a difference if you leave that step out.

[jmanela]

did you check to see if you wired the correct paths for the specified components?

Also try a basic relay program to see if your relay is working (WARNING: be careful though, the comp will not off, so if it works, disable it right away). Then you know it's the IO.

Have you electrical members check the wiring.