|
|
|
 Adding an ounce or two of shields is way easier than filling out the mountains of paperwork for that one impatient person to stick their arm into the robot reaching for who knows what only to have their fingers meet up close and personal with a gearbox. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Black Jaguar CAN Issues
Hi Gang,
When I run into these sorts of problems, it's almost always related to bus termination. The approach of putting the terminator into the RJ-12 is simply too prone to shorting out. It's best to run a short length of wire out of the RJ-12 and solder the terminator externally w/ some heat shrink to keep it safe. HTH, Mike 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bricked black Jaguar after bad firmware update | FRC4ME | CAN | 13 | 19-02-2010 16:52 |
| Black Jaguar Not Taking New Address | duane | CAN | 1 | 06-02-2010 19:55 |
| Black Jaguar RS232->CAN - anyone? | oddjob | C/C++ | 12 | 22-01-2010 16:25 |
| Release Announcement for the MDL-BDC24 (Black Jaguar) | JDNovak | FRC Control System | 2 | 16-12-2009 18:13 |
| The Black Jaguar | David Doerr | FRC Control System | 5 | 25-11-2009 15:43 |
Hybrid Mode
