|
|
|
 Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Re: View block diagram of code that has been deployed as run on start up?
I spent about 2 seconds trying to get debugging to work on an already deployed program last year, following the steps that Kevin posted. It didn't work, and I didn't spend any additional time trying to figure out why. It's quite likely I did something wrong.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ever been asked a simple question, that could have been answered with a search? | Kingofl337 | Chit-Chat | 5 | 21-11-2008 08:35 |
| Vex start up code run PWM outputs without Rx | intellec7 | Programming | 3 | 05-05-2006 23:29 |
| Update 19 has been released | dachickindapit | General Forum | 11 | 13-04-2005 18:08 |
| Nationals Has Been Cancelled!! | 157#1Driver | Rumor Mill | 13 | 01-04-2003 20:56 |
| Has 2vs2 been revealed? | jrukes | Rumor Mill | 15 | 23-10-2001 22:40 |
Hybrid Mode
