|
|
|
 The teams who have the best chance at success are the ones who know where they can save time and money on machining by using or using part of some premade equivalent.
- Bill Gold [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
10-03-2010, 17:20
|
|||
|
|||
|
Re: Black Jaguar CAN Issues
I can't stress enough the importance of a termination resistor on the bus. Without the proper termination, you will get nasty signal reflection on fast edges and that will result in error frames/communication errors.
If you remember SCSI drives, that is why a terminator was necessary on SCSI cabling as well. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bricked black Jaguar after bad firmware update | FRC4ME | CAN | 13 | 19-02-2010 16:52 |
| Black Jaguar Not Taking New Address | duane | CAN | 1 | 06-02-2010 19:55 |
| Black Jaguar RS232->CAN - anyone? | oddjob | C/C++ | 12 | 22-01-2010 16:25 |
| Release Announcement for the MDL-BDC24 (Black Jaguar) | JDNovak | FRC Control System | 2 | 16-12-2009 18:13 |
| The Black Jaguar | David Doerr | FRC Control System | 5 | 25-11-2009 15:43 |
Threaded Mode