|
|
|
 It worked in CAD. - ey206208 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It worked in CAD. - ey206208 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
11-03-2010, 07:56
|
|||
|
|||
|
Re: Vision Target Backing
The vision targets were shipped as lexan sheets with the usual cover over it (the one that generates a ton of static electricity when you pull it off). I know that they were pulled off at Traverse City, and it seems that was the case at *most* regional. However, it appears some opted to not remove the protective film.
I do think the initial intent of the film was just for protective reasons during transport, and therefore was intended to be removed at the events, but I suppose someone out there disagrees with that and didn't do so. =P |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vision target mounting | rath358 | Rules/Strategy | 3 | 13-02-2010 23:19 |
| Vision Target!!! | Pancake | Programming | 4 | 22-01-2010 14:30 |
| Durability of Vision Target | geeknerd99 | General Forum | 13 | 11-02-2006 14:15 |
| vision target | Dakota Snow | Kit & Additional Hardware | 1 | 08-01-2006 23:00 |
Threaded Mode