|
|
|
 Although I don't agree with the ref's call...we accept it because a ref's call is a final call. - David Guzman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Although I don't agree with the ref's call...we accept it because a ref's call is a final call. - David Guzman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
11-03-2010, 12:37
|
|||
|
|||
|
Re: Spikes Not Responding
One other piece of trouble shooting advice.
Make sure the robot is enabled when testing the spikes. We wasted a couple of hours trying to figure out why the spike wasn't responding, and it ended up being that the robot wasn't in an enabled state. ID-10T |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Deployed code not responding | Matt2081 | Control System | 2 | 25-01-2010 15:20 |
| CRio Not Responding | Shadow_Cat | NI LabVIEW | 7 | 13-02-2009 08:12 |
| Motors not responding to joysticks | indubitably | FRC Control System | 6 | 08-01-2009 16:14 |
| grab frame not responding | ahmed | LabView and Data Acquisition | 4 | 28-01-2006 10:49 |
| STAMP II not responding to computer | archiver | 2000 | 4 | 23-06-2002 22:24 |
Threaded Mode