|
|
|
 The math isn't that hard. It's just a tool, like a screwdriver or soldering iron. Sure you get tired of picking up the same old thing everyday, but when you have to tighten a screw you still reach for the screwdriver. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
How To program the second joystick?
Hey everyone!!! Im from team 2121,
originally, we have only one joystick to do both drive and activate the pneumatic kicker. However, that has made the job more difficult because the driver sometimes can not concentrate on driving. So we decide to use the 2nd joystick for the pneumatic kicker. This is how I start Open.vi: joystick open (joy device - usp2) --> refnum registry set (refum name - joystick 2) Teleop vi: refum registry get( refum name - joystick 2) --> joy get --> button 1 Finish vi: refum registry get ( refum name - joystick 2) --> joy close However, it doesnt work. the robot doesnt respond when I press the trigger. Please let me know if there is anything wrong with this code. Thank you Team 2121  
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you program joystick buttons in LabVIEW? | darkpheonix | NI LabVIEW | 10 | 13-04-2014 10:20 |
| How do I program a relay to turn on and off by pressing a button on the joystick? | eweathers | NI LabVIEW | 4 | 28-01-2009 22:34 |
| How to conect solenoids to the circuit board. and how to program it...??? | arpitshah | Pneumatics | 6 | 13-01-2008 15:06 |
| Does anyone have an idea on how to make a joystick program for an operating board? | necroprime | Programming | 8 | 09-11-2002 19:04 |
| Programming the second joystick in PBASIC | archiver | 2001 | 2 | 24-06-2002 00:25 |
Threaded Mode