Caution - Burned out CIM blows Victor

It's about compressing life into 6 weeks. It's about doing. It's about learning to fail. It's about gracious professionalism. It's about releasing the limitations that we all put on ourselves. It's about thinking outside of the box. It's about growing. - JohnBoucher [more]

		Chief Delphi > Technical > Motors
Caution - Burned out CIM blows Victor

Thread Tools

Rate Thread

Display Modes

13-03-2010, 20:29

Ether

systems engineer (retired)

no team

Join Date: Nov 2009

Rookie Year: 1969

Location: US

Posts: 8,100

Re: Caution - Burned out CIM blows Victor

Quote:

Originally Posted by sanddrag

About 0.3 Ohms. Not sure what a new CIM reads. Anyone?

Well, the rated stall current for the CIM is 133 amps at 12VDC according to the drawing. That would imply that the DC resistance is a bit less than 0.1 ohm.

It takes a bit of care to measure low resistances to make sure you have good probe contact.

~

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Burned out 2 5V regulators on Power Distribution boards	jskene	Electrical	5	13-02-2009 11:17
[FTC]: Caution - Tetrix Motors burn out on Stall	ptan	FIRST Tech Challenge	3	11-02-2009 10:19
Victor lights out of sequence	matt99199	Electrical	4	10-02-2009 10:11
Wiring 2 CIM motors to one Victor	ericsundbergva	Motors	2	18-02-2008 10:12
Anybody else burned out?	PMGRACER	General Forum	52	18-01-2004 19:14

All times are GMT -5. The time now is 12:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.