|
|
|
 but eventually it seems that we realize that there's an I in FIRST, and the I stands for Inspiration, not for "me" - MrForbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| but eventually it seems that we realize that there's an I in FIRST, and the I stands for Inspiration, not for "me" - MrForbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Digital Sidecar GPIO output states?
Question for cRIO hardware experts or gurus:
What are the two states of the "signal" pin of the GPIO on the Digital Sidecar when operating in output mode? is it power/ground? or power/float? or ground/float? is it programmable? and if so, does the FRC LabVIEW installation have a VI that fully supports all three modes above? Thanks. ~ 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| crio dashboard GPIO output | darkorbit | Programming | 8 | 09-02-2010 15:29 |
| Using a GPIO pin for both input and output. | Shinigami2057 | C/C++ | 6 | 24-02-2009 20:04 |
| No RSL on Digital Sidecar | shobuda999 | FRC Control System | 16 | 08-02-2009 14:28 |
| Digital Sidecar Problems | cabbagekid2 | FRC Control System | 13 | 31-01-2009 17:23 |
| Digital Sidecar Resistor | NinJA999 | Electrical | 5 | 30-01-2009 19:53 |
Threaded Mode