|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: How to attach an impeller to a CIM motor
I've seen elsewhere that teams have used a gear or pulley system to increase the RPM of the CIM. Don't know what type of impeller they were using, or whether that is an option for you.
If you have access to a lathe, you should probably be able to turn a little aluminum or steel collar for the CIM shaft. You could make it a press fit... but looking at what you've got there... you could probably just put a cotter pin through the whole thing (impeller, collar, CIM shaft) to hold it together. If you don't have access to a lathe...hmmm... a bit tougher decision. Jason |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to attach wire to motors? | jgraber | Motors | 11 | 22-01-2009 16:58 |
| How close can you mount the IFI Controller to a CIM motor | Capt. Quirk | Control System | 8 | 20-02-2008 19:37 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| How do i attach pictures? | Captain Thunder | CD Forum Support | 1 | 22-06-2007 16:56 |
| How to remove pulley from CIM motor | de_ | Motors | 14 | 01-02-2006 20:49 |